DETAILMAX®
Door Edge PPF (Paint Protection Film)
DETAILMAX® Door Edge PPF is a specially cut PPF to protect car door edges from damages, scratches, and chip-offs. Door Edge PPF is optically clear, self-healing, and resistant to yellowing.
XTREME X10
DESCRIPTION
Door Edge PPF
DETAILMAX® Door Edge PPF is Extremely Easy to Apply Without The Need For Professional Training
DETAILMAX® Door Edge PPF is a specially cut PPF to protect car door edges from damages, scratches, and chip-offs. Door Edge PPF is optically clear, self-healing, and resistant to yellowing.
This Door Edge Protection Film ensures that your small mistakes don’t become a big problem.
This Car Door Edge Paint Protection Film can be applied by hand without any tools.
For removing the film from the car door, pick up the corner and pull off at a 90-degree angle.
If the Door Edge Paint Protection Film is applied for a long time on your car, you need to soften the adhesive by using a heat gun or hair dryer before pulling it off.
APPLICATION
Detailmax: Your Car's
Best Care Companion
Wash the Vehicle
Thoroughly clean the vehicle using a high-quality car wash shampoo to remove dirt, grime, and contaminants.
Decontaminate the Surface
Use a clay bar and lubricant to remove embedded contaminants from the paint surface.
Prewipe
Spray on the Panel and Microfiber, and wipe to remove oils. A clean Microfiber cloth should be used forcefully to clear the oils from every inch.
Application of Ceramic Coating
Apply a small amount of the coating to an applicator pad and work it into the paint surface using overlapping, straight-line motions.
Work in Sections
Divide the vehicle into manageable sections to ensure thorough coverage.
Buffing and Levelling
Use a clean, dry microfiber towel to buff and level the coating after applying the ceramic coating. Buff time in 5-10 seconds
Cure Time
The car can be delivered after 2 hours of application. For best results, allow the coating to cure for 12 hours before delivery.
