DETAILMAX®
GMAXv2 Glass & Windshield Ceramic Coating (15ml Kit)
GMAX V2 Glass & Windshield Ceramic Coating Protects all Glass Surfaces With Sio2 Based Nano Particles.
NANO COATING
FEATURES
Instructions: (Post Pre wipe)
Pour a few drops of the liquid onto the applicator pad and apply a thin coat in a circular motion, wait for 5 minutes, and then wipe with a clean microfiber.
Do’s & Don’ts:
- Ensure that the surface of the glass has been cleaned using Pre wipe first.
- At room temperature, the coating will be touch dry, after 5 minutes and fully cured after 12 hours.
- Use a Microfiber cloth to remove the excess residue.
- Avoid contact with water for at least 12 hours after application.
The applicator pads are included in the kit.
APPLICATION
Detailmax: Your Car's
Best Care Companion
Wash the Vehicle
Thoroughly clean the vehicle using a high-quality car wash shampoo to remove dirt, grime, and contaminants.
Decontaminate the Surface
Use a clay bar and lubricant to remove embedded contaminants from the paint surface.
Prewipe
Spray on the Panel and Microfiber, and wipe to remove oils. A clean Microfiber cloth should be used forcefully to clear the oils from every inch.
Application of Ceramic Coating
Apply a small amount of the coating to an applicator pad and work it into the paint surface using overlapping, straight-line motions.
Work in Sections
Divide the vehicle into manageable sections to ensure thorough coverage.
Buffing and Levelling
Use a clean, dry microfiber towel to buff and level the coating after applying the ceramic coating. Buff time in 5-10 seconds
Cure Time
The car can be delivered after 2 hours of application. For best results, allow the coating to cure for 12 hours before delivery.
