DETAILMAX®
WMax Alloy Wheel Ceramic Coating (30ml Kit)
WMax Alloy Wheel Ceramic Coating adds extra mettle to the metal in stylish alloy Wheels.
WMAX
FEATURES
Instructions:
Pour a few drops of liquid on the applicator pad and spread over the surface of the rims and then wipe off the excess material and buff.
Do’s & Don’ts:
- Wait for the Flash Time of 1 to 2 minutes and let the coating settle, then wipe off excess and buff with Microfiber.
- It is necessary to use an enclosed area at a temperature below 28 Degrees Celsius to avoid contamination and get the best results.
- Allow the coating to cure for 12 hours before getting the wheels wet.
Ceramic Applicator Pads are included in the Packaging.
APPLICATION
Detailmax: Your Car's
Best Care Companion
Wash the Vehicle
Thoroughly clean the vehicle using a high-quality car wash shampoo to remove dirt, grime, and contaminants.
Decontaminate the Surface
Use a clay bar and lubricant to remove embedded contaminants from the paint surface.
Prewipe
Spray on the Panel and Microfiber, and wipe to remove oils. A clean Microfiber cloth should be used forcefully to clear the oils from every inch.
Application of Ceramic Coating
Apply a small amount of the coating to an applicator pad and work it into the paint surface using overlapping, straight-line motions.
Work in Sections
Divide the vehicle into manageable sections to ensure thorough coverage.
Buffing and Levelling
Use a clean, dry microfiber towel to buff and level the coating after applying the ceramic coating. Buff time in 5-10 seconds
Cure Time
The car can be delivered after 2 hours of application. For best results, allow the coating to cure for 12 hours before delivery.
